What happened to the sudden stop of the jaw crusher?

The jaw crusher will have a sudden situation in the work. If the cause is not found and repaired in time, it will have a great impact on the entire production. Today, I will explain the reasons and solutions for the sudden stop of the jaw crusher caused by the jaw crusher.
 

1. When the adapter sleeve used to fix this device is loose, the eccentric shaft is stuck in the machine and there is no way to work together. The correct method is to check all parts of the machine for looseness, and tighten or replace the bushings in time.
2. The discharge port is blocked; Solution: Clear the blockage of the discharge port of the crusher to ensure smooth discharge.
3. The V-belt driven by the crusher driving the grooved wheel is too loose, causing the belt to slip; Solution: Tighten or replace the V-belt.
4. The working voltage is too low and cannot be broken when encountering large materials. Solution: Adjust the working voltage to make it meet the requirements of the host.
5. The bearing is the central part of the machine and the main broken part. If the bearing is damaged, it will not work normally with other broken parts, which will cause the jaw crusher to stop. In the daily operation, we must pay attention to the maintenance of the bearing, and if it is found to be damaged, replace it in time.
   When using the jaw crusher, we must pay attention to the maintenance work of the crusher. We must regularly check and repair the crusher so that we can grasp the situation of the crusher in a timely manner. Once there is something wrong with us It will not be too busy, nor will it affect our production efficiency. At the same time, the service life of the jaw crusher can be extended. In the long run, maintenance of the crusher is one of the essential guarantees for our safe and effective production.