Suggestions for reducing dust of jaw crusher

The jaw crusher is a machine that breaks large pieces into small pieces. During the operation process, it is inevitable to produce certain fine particles, that is, dust. If you want to reduce the dust of the jaw crusher, what should you do? What? Today, the editor provides some solutions for everyone.

To reduce the dust of jaw crusher, just do this:

1. Set a sealing cover at the source of the dust, and at the same time configure a water spray and dust suction device.
   a. Set two water spray nozzles at the inlet and outlet, the direction of the water spray nozzle must be reasonable, pointing to the source of dust.
   b. A vacuum cleaner is arranged at the maintenance port behind the movable jaw of the crushing chamber, and the air duct connected with the fan is made into a retractable pipe, so as to facilitate the daily care of the equipment.
   c. Configure a water spray device on the conveyor belt to reduce the dispersion of dust during transportation.
2. Optimize the transformation of the chute chute tooth plate and other structures.
   a. Properly reduce the inclination angle of the chute chute, so as to reduce the potential difference of material height.
   b. Increase the number of teeth of the tooth plate if the other conditions remain unchanged.
   c. Replace the damaged sieve plate in time to avoid the problem of dust increase caused by material blockage.